What years will a 4l60e transmission fit

The transmission has a square oil pan. The key distinction of the Later 4L60-E (1996-2010) from the Early 4L60-E (1992-1997), 4L60 (1990-1992), or 700R4 (1982-1989) is the six-bolt “hex” rear output or tailhousing / adapter pattern.

What vehicles does a 4L60E transmission fit?

Applications

  • Buick Rainier, 2004-2007.
  • Buick Roadmaster, 1994–1996.
  • Cadillac Escalade, 1999-2000, 2002-2005 (models with LM7/5.3L V8 Also with 6.0 LQ9)
  • Cadillac Fleetwood, 1994–1996.
  • Chevrolet Astro, 1993-2005.
  • Chevrolet Avalanche, 2002-2008.
  • Chevrolet S-10 Blazer, 1994-2005.
  • Chevrolet Camaro, 1994–2001.

Are all 4L60E transmissions the same?

The 4L60E is differentiated into an early version and a late version. … While a number of differences exist, the easiest to recognize externally is the fact that the bell-housing is removable for the Late 4L60E transmissions. The replacement began in 1996 but was not fully phased in until 1998.

Will a 1999 4L60E fit a 2003?

From 1999 (LS applications w/300MM input/turbine shaft) through EARLY 2006 any 4L60E from behind a V8 application will interchange with other V8 equipped vehicles. Of course, you have to watch the 2 wheel drive, or 4×4 changes but INTERNALLY, ALL 1999-early 2006 transmissions are the same…

IT IS INTERESTING:  Question: What transmissions will fit a 351 Windsor

Will a 98 4L60E fit a 2000?

1996-1998 will all interchange. 1999-up will not interchange with anything previous as the GenIII engines used a transmission with different length input shaft, among other things.

Why is the 4L60E a bad transmission?

the transmissions break because of lubrication problems. you have to drill feed holes and such. the strongest components you can get will break if they’re overheating because no tranny fluid is getting to them. you have a max evil trans, which is just a 4L60E thrown together with better parts.

How much horsepower can a 4L60E transmission handle?

Their Stage 2 Pro Race transmission can handle gobs of power while their Invincible Black Edition 4L60E trans can support over 1,000 ponies.

What is the difference between a 4L60 and a 4L60E transmission?

The biggest difference between the 4L60 and 4L60E is how they are controlled. The 4L60E is controlled by a computer, while the 4L60 is controlled by a TV cable. … If you were to try to put a 4L60E where a 4L60 once was you’d have to buy an aftermarket transmission controller for it.

Can I put a 4L80E in place of a 4L60E?

Swapping from the 4L60E to the 4L80E is not difficult to do in vehicles that were equipped with both transmissions. Here are the main parts that you are going to need in order to make your own 4L60E to 4L80E swap kit. It’s not the easiest swap to do, and a 4L60E can handle a lot of power on its own.

Can you run a 4L60E without a computer?

Externally, all it needs is a 12-volt source and an engine-vacuum reference. However, if your trans is, in fact, a 4L60E, running it off a computer is mandatory. … Never mind TCC lockup; without a computer, the trans won’t shift at all.

IT IS INTERESTING:  Question: How many kVA is a 3hp motor

What year did the 4L60E transmission come out?

GM 4L60E Transmissions Are Some of the Best on the Market

This transmission was introduced in 1982, and the 4L60E transmission is a branch off this model. The “E” stands for the “E”lectronically shift controlled version.

Are 4L60E and 4L65E interchangeable?

Are they Interchangeable? The 4L65E was designed with the LS V8 engines in mind. They are not directly compatible with the 4L60E because they use a different torque converter and input shaft.

Is a 700R4 the same as a 4L60E?

You can’t tell the difference between a 700R4 and a 4L60E by the oil pan as they are nearly the same. If the transmission has a large 18-pin electronic connector above the passenger side pan rail, it’s a 4L60E, as seen here. If it has a cable connection near the cooler lines on the passenger’s side, that’s a 700R4.

Will a V6 4L60E fit in a V8?

There is absolutely no difference in the internal parts (Hard parts) of the V6 or V8 4L60E.

Can I swap a 4L60E with a 700R4?

You can use a 700r4, besides the TV cable, and wiring up a torque convertor lock up switch, you would need a VSS for the ECM and your speedo. I would stick with the 4L60E like others are saying though, if you can afford it. They are a little bit stronger.

Does a 4L60E have a kickdown cable?

The 4L60-E and the 4L80-E electronic controlled transmissions are not equipped with a Throttle Valve (TV) cable assembly. The transmission functions normally controlled by the TV cable are controlled electronically…

Four wheels